Suzuki GSXR600/750 K6/K7

[dave31]

Hi a good friend of mine has been forced to sell off his race bike and is going back down to KZN at the end of the month.

When his 750's motor blew we bought an insurance write off bike and transplanted the motor over.

So we still have the following parts that are available that he needs to get rid of before the end of the month:

Main frame - 600/750 is the same for these models
Rear Subframe
Right front footpeg with brake lever
Rear pillion footpegs with hangers.

CDI unit
Full set of Throttle bodies
ECU
2 blank Suzuki keys from the USA


Will add other bits as Grant finds them.....

You can mail him on grant@shearvision.co.za or call on 08337580fivefive

[dave31]

OK - Full list

full frame, sub frame and swing arm
full OEM exhaust, header pipes and tail piece
radiator
side stand
right hand foot rest
fule pump (needs a good clean)
two blank keys
shark fin
Yoshimura case savers (old ones, have been repaired and re painted)
rear axle
about 3 sets of partly used brake pads (Carbon Lorainne race pads)
a very damaged head but 3 sets of valves that can be used
a collection of shims
set of clutch plates (I replaced clutch plates and then discovered that is was the springs that were gone)
nuts, bolts, some still in original Suzuki packaging

[4agedub]

Hi
Does the k7 header fit onto a k8? This might make for an easy decat route without having to chop mine....

[dave31]

Hi
Does the k7 header fit onto a k8? This might make for an easy decat route without having to chop mine....

Hi

Not too sure..... maybe phone your local Zook dealer and check. It would just be the mid-box that you would chop and not necessarily the header pipe as far as I know.

[SanMan]

Hi
Does the k7 header fit onto a k8? This might make for an easy decat route without having to chop mine....

yes it will fit. check the link below
http://www.gixxernation.com/forums/s...7-header-on-k8

[dave31]

Grant is moving to Natal next week so if you need anything please get in touch with him ASAP..

Thanks!

[4agedub]

Exhaust sold to me

[dave31]

Thanks 4agedub!